This Wilson Combat WCP320/WCP365 Tungsten weight kit is the perfect solution for those looking to enhance their recoil control and improve their firearm's balance.
This Wilson Combat WCP320/WCP365 Tungsten Weight Kit is the perfect solution for those looking to enhance their recoil control and improve their firearm's balance. The kit includes three tungsten weights that easily slide into a module to provide extra weight and greater balance while shooting your Sig P320/365. With this kit, you can customize your firearm to meet your specific needs and shooting style.
NOTE: Because these weights are a drop-in fit, apply a dab of heavy grease to prevent any potential rattle with some frames. For a more permanent installation, silicone caulk adhesive is a great choice.
Disclaimer: "SIG" is a federally registered trademark of SIG SAUER Inc. and is one of many trademarks owned by SIG SAUER Inc. Neither Wilson Combat nor this website is affiliated in any manner with or otherwise endorsed by SIG SAUER Inc. The use of "SIG" or "SIG SAUER'' on this page is merely to advertise the sale of SIG pistols, parts, or components. For genuine SIG SAUER Inc. products and parts, visit Sig Sauer.
I bought the p320 compact module along with these weights. The two smaller weights fit snug beside the holes in the module are conical. The center one does not. I used some permatex 81158 black rtv and it worked great. Just coat the weights generously, push them in with a punch and clean up the excess and let it dry. The two side weights take some pressure to seat all the way as they’re an interference fit towards the bottom. The center weight does not take any pressure.
Wilson combat didn’t even do engineering behind this. I love the brand and will keep buying product but these weights add little to no weight to the grip module. Recoil felt the same and even after putting them in. Little no no weight was added overall. Very disappointed.
The center weight should have been thicker so a snug fit would be had. and they all could have been longer. I took a small rubber band , cut an inch of it , and put it down the side of the weight and the weight is snug and does not rattle and if it needs to be removed, will be easier, no mess, like silicone.
These weights took about 30 seconds to install. Pressed into place firmly they fit snuggly and do not rattle. I did not use any adhesive. With the Wilson grip module and tungsten weights the P320 now feels much more substantial and has better balance in the hand. A joy to shoot!
these work great and fit but will flop around if not secured by a glue or silicon. I used silicone caulk to seal these weights in place
These add just enough weight to the grip module! My XCompact feels much better in hand and has less perceived recoil after installing these. The kit does NOT come with silicone but it is advertised as not coming with it. It's available everywhere, and I actually had some laying around. The installation was a breeze. Be sure to have Silicone, cotton swabs, rags or towels, and a punch ready. Those things make for a quick and proper install.
I'm assumming some are talking about silicone sealer to insure rods don't move or rattle.
Very satisfied overall, good feel in the hand, but like others I would be happy to pay an extra couple of $$ and not have to make an extra journey for silicone to finish the job.
Order arrived with only two weights.
