REAR SIGHT, GLOCK, VICKERS ELITE, BATTLESIGHT, SERRATED BLADE, BLACK

Transform your Glock handgun with the Vicker's Elite Battlesight. This sight is designed for precision accuracy, featuring a .325" height and a unique U-notch design measuring .145" deep that works in conjunction with the slim, yet effective,.125” wide front sight to guarantee maximum precision when sighting downrange. The rear blade is serrated with 40 LPI (Lines Per Inch) to reduce glare and its shelf-like shape allows for easy one-handed manipulation of the slide. Finished in a durable, matte black parkerized finish, this sight will take your competitive shooting performance to the next level. 

• Height: .325"
• Blade Height: .245"
• U-Notch Depth: .145"
• 40 LPI serrations
• Requires .245" front sight if a 9mm or .40 S&W
• Requires .230" front sight if a .45 ACP or 10mm

Installation Instructions:

1. Remove the magazine and make sure your pistol is unloaded.
2. Remove and Field strip slide assembly and secure the slide in a padded vise.
3. Remove existing rear sight with hammer and punch.
4. Clean rear sight dovetail and press in new rear sight from right to left. If rear sight will not start into approximately 50% of the dovetail you may need to remove very small amounts of material from the bottom and sides of the dovetail portion of the rear sight-usually just a few light passes will do. A safe sided dovetail file, small diamond hone or sanding stick are good tools for this. Go slowly and check your fit.
5. Once you are able to get 50% of the sight base into the dovetail attempt to tap the sight in place with a hammer and non marring punch/dowel (wood, polymer, aluminum) or appropriate sight pusher. If using a steel or brass punch protect the sight/punch with several layers of duct tape.
6. Fine adjust your windage with a rear sight armorers tool or non marring punch.
7. After you fine adjust rear sight windage install dual locking screws with a threadlocking compound like Loctite on the threads.
8. Note-if the rear sight is loose in the dovetail your dovetail is cut oversize and the new rear sight may require peening on the edges of the dovetail for a proper fit. 

Larry Vickers is a retired US Army 1st SFOD- Delta combat veteran with years of experience in the firearms industry as a combat marksmanship instructor and industry consultant. Find out more about Larry Vickers on his website Vickers Tactical.

"GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither Wilson Combat, nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.