SAFETY/DE-COCKER, BERETTA 92/96 F/FS, STANDARD, SINGLE LEVER

Its extremely stiff to disengage, i had to use a plastic pen and then put some leather gloves on, i oiled it and worked it 100 times. Its a little better but really tight to disengage still, the other side sticks out and is really pointy and sharp and the safty is extremly sharp. Also when you put the safty on the other side still shows a red your dead mark wven though the safty is on and thats pretty stupid. I just leave the safty off and since its so stiff its not too likely to come on.

I replaced the hand-shredder on-slide levers with the standard single-lever safety/decocker from WC and it was a life changer. There’s a great install video from Average Doomsday Prepper Dude on YouTube that’s all you need for the DIY install...a couple of fiddly springs so I strongly suggest you work inside a big ziplock food storage bag to keep from shooting them across the room...but beyond that it was a breeze and it works like a charm!!!!!!! You’ll need the proper punches and tools, but ADPD lays those out for you. Can’t recommend this enough for anyone looking at inadvertent safety activation when overhanding (or ripping your hand to bits). Retains both the safety and the decocker function but makes your 92 easier to maniupulate and conceal. I’d give it 6 stars if I could. Strongly recommend.

Great piece!. I wanted a one-sided lower profile safety/de-cocker so I purchased the low profile version - Functioned well, but profile was too low if hands should have sweat, blood, or gloves on them. I opted for the "standard" single sided de-cocker planning to grind down the profile to somewhere between the "low profile" and the stock Beretta part. To my pleasant surprise, the Wilson Combat part was already about 1 mm. lower profile than the stock part. No modifications necessary! Perfect!

Absolutely love this conversion kit, works perfectly fits the pistol with ease!

At first I was apprehensive about installing this one over the low profile version Im happy I decided on this one; it gives the same amount of purchase as the oem part. I found it to be very easy to install just be sure to lay a rag over the gun and your hands to prevent the pins and springs from launching into the abyss .

Does a pretty good job of slimming down the pistol for carry purposes. Much less to snag clothing on and yet large enough to easily disengage the safety under stress. The thumb catch is the same size as the stock part. Easy drop in part to install. Lots of YouTube videos about it. Just dont forget to install everything in a sandwich bag. I was chasing springs and detents all over the living room at one point.

I installed this today and went to the range to try out my 92fs after installing all the other Parts I bought from WC. The gun shoots great and the function is so much better. Now one of the Range Officer wants me to put all the same parts in his gun.

Im right-handed. I think ambi-safeties clutter a gun. About a year and a half ago I put the decocker-only version of this product on my Elite, which is a G. Its really tidy. Today I put the safety-decocker on my FS Centurion. It looks great. I might mention that on Beretta FS guns I use the lever as a decocker only -- never as a safety. Its so easy to flip it on and off that I really dont miss it being a G model.

Works great, very happy with product. It is very easy to engage the Safety. However, this part was not drop in. I just couldnt get it to fit properly. I took it to a gunsmith to have it installed. He said it was off 1/5000 on an inch. It doesnt seen like a lot but it now fits perfect. Anyway its a great upgrade which may have to be installed by a gunsmith.